mART Plate for stamping buy at AmoreShop
Plate size: 12×6 cm.
The mART stamping plate will help you make a clear pattern on the manicure.
The plates have the correct notch depth, so the drawings are very clear, even with the thinnest lines.
mART stamping instructions:
1. Apply some paint to the plate.
2. Remove excess paint with a scraper. Hold the scraper at a 45-degree angle and sweep the scraper across the surface of the plate with a quick, sure motion.
Important: pressure on the scraper should be moderate. Pressing too hard will not distribute the paint well over the selected pattern, too weak will not remove all the excess.
3. Take the stamp and with a rolling motion, without strong pressure, roll the stamp over the plate.
Important: the rolling movement must be done only once!
4. Now the picture is on the stamp. At this stage, you can carefully remove unnecessary details of the pattern from the stamp with a toothpick, if necessary.
5. With a rolling motion, without strong pressure, transfer the pattern from the stamp to the nail.
Tip: if you don't like the result, you can remove the stamping with a sticky roller (these are sold to remove dust from clothes) and try again.
6. Cover the nail with a top coat.
Tips from the mART company:
To clean the plate and stamp you will need:
Nail polish remover
Lint-free napkins
A roller with sticky tape or tape
Clean the plates with lint-free cloths soaked in a nail polish remover with a small amount of acetone and without oils, or use a gel nail polish remover.
It is better to clean the stamp with ordinary tape with the sticky side.
Let the plate dry after rubbing, otherwise the pattern will "float".
Plates must be cleaned from previous use.
Use paint with dense pigmentation.
Observe the temperature regime in the room so that the paint does not dry too quickly.
If you are unable to transfer the drawing from the plate to the nail, pay attention to these recommendations:
• The most important thing is that the stamping plate has the correct notch depth - this is the key to the clarity of the drawing.
• If you work with stamping paint, remember that it dries quickly, which means you only have 3 seconds to transfer the design from the plate to the nail. And the paint should be at room temperature, do not store it in the refrigerator and do not put it in the sun.
• Practice, do not give up at the first failure, work quickly and the paint will not have time to dry.
• Unable to reprint the drawing? Then, probably, you put a lot of pressure on the stamp. The stamp is quite soft and elastic, do not press on it, do it gently, with light pressure.
• The next rule is to roll! Apply the stamp for stamping to the plate with rolling movements and transfer the pattern in one movement.
• Now it seems that everything is fine, but the fine lines do not come out? Well, then get a different stamp because the silicone stamp can overprint fine lines. If you have different stamps, the pictures will come out perfectly.
• Silicone stamp does not want to work? It is not advisable to wipe it with various liquids so that it is not wet, it is better to use simple tape with it. Take the scotch tape and remove the remnants of the pattern from the stamp with the sticky side.
• How to wipe the plate now? Take gel polish or nail polish remover, put it on a lint-free tissue and carefully wipe all the fine lines on the plate, let it dry and rub the stamping plate to a shine, as soon as you see your reflection, the plate is ready to go again.
Why should you order mART Stamping plate from our website
The Amoreshop store always offers a wide range of products at a low price, and the loyalty program for customers will allow you to quickly solve questions about the product you are interested in.
You can familiarize yourself with the entire range of products by going to https://amoreshop.com.ua/
