mART Stamping plate 007 (Ukrainian words)

mART stamping plate buy at AmoreShop

Plate size: 12×6 cm.

The mART stamping plate will help you make a clear drawing on a manicure.
The plates have the correct notch depth, so the drawings are very clear, even the thinnest lines.

mART stamping instructions:

1. Apply some paint to the plate.
2. Remove excess paint with a scraper. Hold the scraper at a 45 degree angle and move the scraper across the surface of the plate in a quick, steady motion.
Important: the pressure on the scraper should be moderate. Pressing too hard will not distribute the paint over the selected pattern, too weak will not remove all the excess.
3. Take the die and in a rolling motion, without applying too much pressure, roll the die over the plate.
Important: The rolling motion only needs to be done once!
4. Now the drawing on the stamp. At this stage, you can carefully remove unnecessary details of the pattern from the stamp with a toothpick, if necessary.
5. With a rolling motion, without pressing hard, transfer the pattern from the stamp to the nail.
Tip: If you don't like the result, you can remove the stamping with a sticky roller (these are sold for removing dust from clothes) and try again.
6. Cover the nail with top coat.

Tips from mART:

To clean the plate and die, you need:
Nail polish remover
Lint-free servos
Roller with sticky tape or tape
Clean the plates with lint-free wipes dipped in nail polish remover, with a small amount of acetone and without oils, or use gel polish remover.
It is better to clean the stamp with ordinary adhesive tape with the sticky side.
Let the plate dry after lapping, otherwise the pattern will be "floated".
Plates must be cleaned from prior use.
Use paint with dense pigmentation.
Observe the temperature in the room so that the paint does not dry out too quickly.

If you are unable to transfer the pattern from the plate to the nail, then pay attention to these recommendations:

• The most important thing is that the stamping plate has the correct notch depth - this is the key to the clarity of the pattern.
• If you are working with stamping paint, then remember that it dries quickly, which means that you have only 3 seconds to transfer the pattern from the plate to the nail. And the paint must be at room temperature, do not store it in the refrigerator and do not put it in the sun.
• Practice, don't give up on the first setbacks, work fast before the paint dries.
• Can't reprint the pattern? Then, perhaps, you put a lot of pressure on the stamp. The stamp is quite soft and elastic, do not put pressure on it, do it gently, with light pressure.
• Next rule - roll! Apply the stamping stamp to the plate with a rolling motion and transfer the design in one motion.
• Now everything seems to be fine, but thin lines are not obtained? Well, then get a different stamp, because the silicone stamp can overprint fine lines. If you have different stamps, then the drawings will turn out perfect.
• Silicone stamp doesn't want to work? It is not advisable to wipe it with different liquids so that it is not wet, it is better to use simple adhesive tape with it. Take the tape and use the sticky side to remove the remnants of the pattern from the stamp.
• How to wipe the plate now? Take gel polish or nail polish remover, apply it on a lint-free cloth and carefully wipe all the fine lines on the plate, let it dry and rub the stamping plate to a shine, as soon as you clearly see your reflection, the plate is ready to work again.

Why you should order mART Stamping Plate on our website

Amoreshop always offers a wide range of products at a low price, and the customer service will allow you to quickly resolve your issue.

You can get acquainted with the entire range of goods by going to the address https://amoreshop.com.ua/ua/