Machine for manicure ZS-717 buy in Amoreshop
Machine for manicure ZS-717 - has a high power of 65 W, which will easily allow you to perform hardware manicure, correction and pedicure. Provides low operating noise with minimal vibration.
The handle fits comfortably in the hand and has a professional clip that allows you to quickly change attachments. Has two directions of rotation: direct and reverse.
The milling cutter is equipped with a large LCD-display, which displays: the operating mode, the number of revolutions, the direction of rotation of the cutter. There is protection against voltage surges - built-in fuse.
The set includes:
- a set of 6 attachments,
- foot pedal,
- power unit,
- micromotor handle,
- stand under the handle.
Power: 65W
Voltage: 220-240V, 50Hz
Maximum number of revolutions: 35000 rpm.
Torque: 1.94 * N / cm
Unit dimensions (+/-): 150 * 150 * 91mm
Approximate unit weight: 0.908 kg
Handle length (+/-): 15.5cm
Approximate handle weight: 0.106 kg
Warranty period: 3 months
User manual for Nail Drill ZS-717:
- Need to connect the handle to the main unit
- Next, the pedal is connected
- Then we insert the nozzle into the handle and fix it. It is not recommended to turn on the device without a nozzle!
- Now we select the operating mode Foot or Hand, foot or manual.
- To regulate the speed in manual mode, we use a rotary regulator, in foot mode, a pedal. It is undesirable to work at maximum speed.
- You can change the direction of the cutter using the reverse. It is best to do this in the off state.
Attention!
There may be a voltage switch on the back of the router, which must always be in the 220 V position, otherwise the device may burn out.
The router must be placed on a flat surface not covered with cloth to avoid blocking the holes in the bottom of the block. Otherwise, the appliance may burn out. The time of continuous work with the milling cutter is limited. During use, it is necessary to check tactilely (by hand) the heating temperature of the milling unit: if it is hot, then work must be interrupted and wait until it has completely cooled down. Do not forcibly cool the router (put it under an air conditioner, put ice, use a hair dryer, etc.), as this can damage the board. To avoid problems associated with a voltage drop in the network, it is recommended to connect the router through a voltage stabilizer. After serving two or three customers, it is necessary to clean the router handle by disassembling it and removing sawdust particles.
Why it is worth ordering the Machine for manicure ZS-717 on our website
Amoreshop always offers a wide range of products at a low price, and the customer loyalty program will allow you to quickly resolve questions about the product you are interested in.
You can get acquainted with the entire range of goods by going to https://amoreshop.com.ua/
